NAC/10A is a cost effective 10 Amp Power Limited Voltage Regulated remote Notification Appliance Control (NAC) expander unit. It may be connected
to any UL Listed 12 or 24 Volt DC Fire Alarm Control Panel.
The NAC/10A supports all ADA requirements and will provide power to ancillary equipment with two Aux outputs (one automatically battery backed-up and one not). Each Aux. Output is rated for 1 Amp. The unit comes with either four Notification Appliance Circuits Class B (Style Y) or four Notification Appliance Circuits Class A (Style Z). All circuits are rated for a maximum of 2.5 Amps each (not to exceed 10 Amps per supply). The NAC outputs can be independently programmed for Steady, Temporal or Strobe Synchronization. The outputs may also be programmed as "follower circuits" that will code following their inputs (eg: Sync in = Sync out). Any two NAC Circuits may be paralleled to supply a single output of 4 Amps. Trouble is reported either through a set of common Trouble Dry Contacts or through the Input 1 or Input 2 terminations. Inputs can be programmed to trip any combination of up to 4 outputs.
The unit features a "Loop Output" trouble memory for aid in troubleshooting problem field circuits. Charges up to 65 Amp Hour Batteries with a programmable AC Fail delay.
>> SPEC SHEET
NAC/6A is a cost effective 6.5 Amp Power Limited Voltage Regulated remote Notification Appliance Control (NAC) expander unit. It may be connected to any UL Listed 12 or 24 Volt DC Fire Alarm Control Panel. The NAC/6A supports all ADA requirements and will provide power to ancillary equipment with two Aux outputs (one automatically battery backed-up and one not). Each Aux. output is rated for 1 Amp.
The unit comes with either four Notification Appliance Circuits Class B (Style Y) or four Notification Auxillary Circuits Class A (Style Z). All circuits are rated for a maximum of 2.5 Amps each (not to exceed 6.5 Amps per supply). The NAC outputs can be independently programmed for Steady, Temporal or Strobe Synchronization. The outputs may also be programmed as "follower circuits" that will code
following their inputs (eg: Sync in = Sync out). Any two circuits may be paralleled to supply a single output of 4 Amps. Trouble is reported either through a set of
common Trouble Dry Contacts or through the Input 1 or Input 2 terminations. Inputs can be programmed to trip any combination of up to 4 outputs.
The unit features a "Loop Output" trouble memory for aid in troubleshooting problem field circuits.Charges up to 65 Amp Hour Batteries with a programmable AC Fail delay.
>> SPEC SHEET
| 
